jannes_z-28
06-27-2006, 12:22 PM
Well everything is coming along. Have started to connect the wiring and so. A lot of small details to finalize.
I made my own bracket for the Vintage Air unit. It is a little further away from the firewall than the DSE I believe. The room between became perfect for the PCM and it turned out that it could be there without cutting any cables in the harness. I cut a hole in the firewall just outside of the cylinder head. It will not be seen much from the engine bay when everything is in place.
http://www.protouring.se/files/almost2.jpg
The enginebay is getting there. I made a fanshield to fit my '69 radiator and placed two electric fans there. The fans will be controlled from the PCM with high and low speed as GM did it. Three relays are involved for that.
http://www.protouring.se/files/almost1.jpg
Jan
I made my own bracket for the Vintage Air unit. It is a little further away from the firewall than the DSE I believe. The room between became perfect for the PCM and it turned out that it could be there without cutting any cables in the harness. I cut a hole in the firewall just outside of the cylinder head. It will not be seen much from the engine bay when everything is in place.
http://www.protouring.se/files/almost2.jpg
The enginebay is getting there. I made a fanshield to fit my '69 radiator and placed two electric fans there. The fans will be controlled from the PCM with high and low speed as GM did it. Three relays are involved for that.
http://www.protouring.se/files/almost1.jpg
Jan