Mil-Spec bulkhead connector

[BigVin]

I'm looking for someone who biulds Mil-Spec bulkhead connectors like Wires to Pliers biult or where Ican get the same parts and biuld my own.

PLEASE HELP

[parsonsj]

Vin,

Drop Frank at Prodigy Customs a line. He's looking into it.

jp

[slowcamaro]

I not sure whether it was buried in this thread

http://corner-carvers.com/forums/showthread.php?t=34419

or this one

http://corner-carvers.com/forums/showthread.php?t=30257

but a search of "mil-spec" "connector" and/or "bulkhead" will likely turn up a link leading to what you are looking for.

[BigVin]

thanks slowcamaro the first link had good imformation. I learned a little but still don't have a clue.
Vin

[BigVin]

anyone

[G-TX]

http://www.connecticc.com/default.aspx?Page=Military_Connectors
http://www.connecticc.com/images/connectorgroup2.jpg
These are the type on the eguip. I worked on in the Navy.Sure would be fun to assemble a car harness.

[BigVin]

http://www.connecticc.com/default.aspx?Page=Military_Connectors
http://www.connecticc.com/images/connectorgroup2.jpg
These are the type on the eguip. I worked on in the Navy.Sure would be fun to assemble a car harness.
G-tx
Thanks for the link. I'm looking for mil 38999 ms27466 I need 8 12 ga. some 16, 18, and some 20s if you could give me some part #s that would be great.
thanks again Vin

[G-TX]

I thought about doing a car in mil-spec/Cafe Racer style in the 80's,flat grey/green bare interior,aircraft seats,gauges,wiring,etc. I think the easiest/cheapest way to do it would be using surplus A/N cables.The surplus store in San Diego I used to haunt was full of them.I got all my A/N fittings and filters there.It would be simple enough to cut off one end of the pre-built cable and attach to your MSD,injectors,or whatever.Then get a bulkhead connector for the dash or electronics box.Sometimes you get lucky and find an extension cable.Then you got both male & female ends ready!